P/N: ETI0019-2110E
Tactical Wheeled Carry-On UPS
Rating: 1000 VA, 750 Watt
Input: 85-270 VAC, 45-70 Hz
Output: 120 VAC, 50/60 Hz
|
P/N: ETI0019-2110E
Tactical Wheeled Carry-On UPS Rating: 1000 VA, 750 Watt Input: 85-270 VAC, 45-70 Hz Output: 120 VAC, 50/60 Hz |
Transportable
Tactical 1 kVA UPS  |
| AC OUTPUT | |
| Output voltage: | 120 VAC true sinewave output standard |
| Output rating: UPS | 1000 VA, 750 watts standard, |
| Non-linear load capacity: UPS | Up to 100% non-linear load capability w/o derating |
| Output voltage regulation: UPS | ± 3.0%
static regulation of nominal ± 4.0% dynamic (0 to 50% load step) |
| Overload surge capacity: UPS | 110% for 10 minutes; 125% for 30 seconds |
| Harmonic distortion: UPS | Less than 5.0% into 100% non-linear load |
| Output frequency: UPS | 60
Hz or 50 Hz switch selectable ± 2.5% synchronized to utility ± 1.0% w/ utility not available |
| Operational status | AC Input status, UPS
operational, UPS alarm, Battery level, Low battery, Load level, Overload, Warm/Hot temperature, Battleshort LEDs, +90 dB audible alarm w/audible on/off switch |
| AC INPUT | |
| Input voltage selection: | Autoranging from nominal 85 VAC to 270 VAC |
| Input voltage tolerance: UPS | +15%
-25%, or 85-140 and 170-280 @ full load without using battery, to 70 VAC @ 75% load |
| Input frequency: | From 45 Hz to 70 Hz standard, optional to 440 Hz |
| Input power factor: | Better than 99% typically |
| Input/output isolation: | up to 120 dB common mode, <1.0 ma leakage |
| Input transient suppression: | Complies with IEEE 587, UL 1449 and Mil Std 1399 |
| Input control/protection: | Recessed 100 G shock rated circuit breaker (CB1)|
| Input power connections: | One IEC320 male, 3 pin |
| INTERNAL BATTERY | |
| Internal battery type: | Maintenance
free immobilized electrolyte, Flame retardant materials (Oxygen Index 28+) |
| Internal battery life: | Rated for continuous service life of 5 years |
| Internal battery protection: | Recessed 100 G shock rated circuit breaker (CB2) |
| Internal battery time: | 5+ minutes @ 750 watt load, 12+ minutes @ 50% |
| Internal battery recharge: | Recharged to nominal in <8 hours |
| Internal battery replacement: | Hot
swap drawout/plug-in module from front of unit <3 minutes to change battery modules |
| Battery expansion: | Up to 24 hours w/ optional Battery Expansion Modules |
| DISTRIBUTION PANEL | |
| Output circuits: | Four AC outputs standard, several optional configurationsFour |
| Output receptacles: AC output | NEMA 5-15R, various options |
| MECHANICAL | |
| Dimensions (H x D x W): UPS | 21.75 x 8.99 x 13.75 in (552 x 228 x 349 mm) |
| Unit weight | 50 lb. (23 kg) |
| Audible noise: | Less than 47 dB @ 5.0 ft., ANSI "A" scale |
| Cooling type: | High capacity, positive pressure, forced air |
| Air intake filter: | Washable metal filter media, others optional |
| ENVIRONMENTAL | |
| Storage temperature: | -40° to 158° F ambient (-40° to 70° C) |
| Operating temperature: | 32° to 126° F ambient ( 0° to 52° C), lower/ higher optional |
| Operating humidity: | 0 to 95% relative humidity (non-condensing) |
| Storage elevation: | Up to 40,000 ft (12,192 m), higher optional |
| Operating elevation: | Up to 10,000 ft (3,048 m), higher optional |
| STANDARDS | |
| United States: | Meets
UL-1778 standard for UPS equipment, Meets MIL-STDs 1275, 167-1, 454, 810, 1399-300A & MIL-S-901 |
| Canada: | CSA C22.2 No. 107 UPS safety requirements |
| EMI Protection: | EMI/RFI FCC Part 15, Class A; EN55022 |
| OPTIONAL ACCESSORIES | |
| Cold Start, Alternate I/O
Configurations, Battery Expansion, Battery Charger/Conditioner, Power Distribution Units |
|